Any electricians

[bigmac]

Treadmill stopped working today its a proform 400c

After a lot of looking about on net it seems the main control board is most likely culprit, there's a little led light on board and if power is on eg: Speed is set above 0 mph the led should light up showing that there's power and in turn it sends a signal to Motor.

However when switched on the led flickers then goes out, all electronics on main dash work and incline also works.

I need someone with electronics background that can check resistors and check if there's any problems with board ?

Anyone help out

Main board is a MC2100E

[paulvectrac]

Possible dry joint Mate am a spark of I was closer I would have a look for ya no probs but am abit far away lol

[bigmac]

Was thinking of removing board and sending away but a guy on ebay wants £12.95 to check board and if its faulty he will mend it for £75

Board is roughly the same size as an envelope

Link to a page about the board http://media.fotki.com/1_p,sqkgdffdt...4725img-or.jpg

[paulvectrac]

How much if you wanna send it to me matey I will have a look and fix for free if I can if I carnt I no a man that will do it for some beers lol

[bigmac]

How much if you wanna send it to me matey I will have a look and fix for free if I can if I carnt I no a man that will do it for some beers lol

Cheers buddy

This is a picture of board

[paulvectrac]

No prob mate If you cover post cost to send it back to you and possible a few tokens for my mate if I carnt do it am 100% shore he can as that's what he makes lol

[bigmac]

Will be in touch mate

[paulvectrac]

No worries fella