Just went out to fit my Insignia windscreen washers and it turns out i have heated washers fitted to the car, are they standard on the GSI?
It was a nice suprise but was looking forward to the mist type jet spray of the Insignia jets.
Just went out to fit my Insignia windscreen washers and it turns out i have heated washers fitted to the car, are they standard on the GSI?
It was a nice suprise but was looking forward to the mist type jet spray of the Insignia jets.
they will fit just you wont have teh heated side
and dont really need them at the min
i just got a set for mine as well
Keep the heated ones for winter and use insignia ones for summer
Yes
Alan, you may want to look into this as there was a recall on the early GSis and Elites as there was a fire hazard from the heated washer jets
The recall involved disconnecting the jets but there is now a revised wiring loom/jets
i am hoping so lol
i will be fitting mine tomorrow night when i fit my new inercooler pipe as i found a hole in one of mine yesterday
be 50 quid i sent on it this week lol
pipe is about 45 quid and the jets just under a fiver
Open your bonnet, pull off the rubber seal at the back, and open the scuttle panel on the passenger side so you can see the pollen filter. Next to the pollen filter is a socket where the heated washer jet loom plugs in.
If you've had the recall, you'll find either there's nothing plugged into it and there's no loom going to the jets, or there's a loom going to the jets but it's unplugged, or there's a loom going to the jets that's been cut and insulated with tape. Some dealers replaced the jets with non-heated ones, some just disabled the heaters by unplugging or cutting the cable...
Most pre-facelifts (other than poverty spec models) have the socket, but not necessarily the heated jets. There's a how-to on fitting them.
how do you know you have heated washers?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks