steering controls

[dcm23251981]

hi are steering controls easy to fit? as i currently dont have any fitted 54 veccy full canbus

[paulvectrac]

What do you mean u dont have any have u bought a brezze or somet like that

[dcm23251981]

dont have any fitted got a 1.8 energy with a cd30

[Grumpy1954]

Never seen aVec with no steering wheel controls, is it the right wheel?

[paulvectrac]

Yep grumpy some didn't come with them am shore Andy I Robesy or kman will be able to sort you out

[dcm23251981]

cheers fella i hope there is a loom some were took air bag out and nothing in and its doing my tree in

[dcm23251981]

cheers fella i hope there is a loom some were took air bag out and nothing in and its doing my tree in

[Robsey]

Have you read my How 2?

http://www.vectra-c.com/forum/showth...=107692&page=3

My wife's 2005 Vectra Energy 1.9CDTi 150 came with CD30, TID and no wheel controls.

I retro fitted CD70, CID and scrollers, which are all very easy to do.

Now then, You will need to solder in 2 wires to the metal tracks in the backing plate for the steering wheel.

I also had to solder in the pins to the metal back plate for the blue scroller control connectors to plug onto.

Very easy to do... I just used pins from a computer drive power connector (CD drive or floppy drive) for the job.

Do not use facelift or other vehicle model scroller controls, as they will not physically fit the steering wheel spokes.

Finally, you will need to get someone to program the CIM to accept the scrollers, otherwise the horn will sound if you touch any of the right hand controls.

This is a two minute job to do in an Energy model, using Tech-2, Op-Com or Vaux-Com.