no heaters on car

**tash** · 22nd January 2012, 13:17

hey guys been a while,,still got me vectra,came to it yesterday went to put heaters on as cold lol, got no heat coming out,nothing on number 1 number 2 number 3 but only on number 4,,,any ideas guys,,,air con the same only number 4 mode,,,, thanks in advance paul,,,,

**vectra ste** · 22nd January 2012, 13:23

http://www.vectra-c.com/forum/showth...t=scuttle+tray

have a read of this

**vectra ste** · 22nd January 2012, 13:24

resistor pack needed

**vectra ste** · 22nd January 2012, 13:26

http://www.vectra-c.com/forum/showth...or+pack&page=3

how to

**troutybrown** · 22nd January 2012, 13:28

http://www.vectra-c.com/forum/showth...=1#post1234916

http://www.vectra-c.com/forum/showth...=1#post1495923

Have a look at these

**vectra ste** · 22nd January 2012, 13:29

Glove box is easy. You'll need a T20 (Torx) bit. Look along the bottom edge of the glove box with it closed, you'll see two or three (can't recall exact number from memory) screws to remove. Same along the top edge. Glove box should now be loose and be able to be removed. Before you just yank it out, pull it out a bit to then let you disconnect the plug on the light that you'll now be able to see. Once you've done that you can safely take it out all the way. the resistor will be at the bottom near the floor.
you will have to do a lot of bending .it may help if the passenger seat is pushed back as far as it will go

**troutybrown** · 22nd January 2012, 13:29

Pah beaten to it lol

**vectra ste** · 22nd January 2012, 13:36

FAN RESISTOR on feabay about 23 pounds
dealers about 32 pounds plus vat

**vectra ste** · 22nd January 2012, 13:38

Originally Posted by troutybrown

Pah beaten to it lol

couldnt load my external hard drive fast enough

**tash** · 22nd January 2012, 13:38

thanks guys,,i will speak to garage moro and get it booked in,,,as i"am useless at out like this,,do we no how much the bit is and rough time on labour ??? as i wont be using vx dealer thanks again