-
5th January 2012, 20:56
#1
Regular Member
P0380 Code
As been discussed previously, this code was present in my CDTi 150, had the glow plugs changed and code cleared.
The spanner light has re-appeared but goes out once started which I believe is not the norm but acceptable.
My point being glow plugs have been changed and spanner light has re-appeared, what is could it be?
Thanks
-
5th January 2012, 21:03
#2
Was the code defiantly cleared as once a code has been set and the fault fixed the light will still come on at engine start and then go straight off.
I would get the codes read/cleared again.
-
5th January 2012, 21:07
#3
-
7th January 2012, 22:00
#4
Regular Member
Hi there mate i have the same fault on mine. It starts perfect every time and first thing in morning spanner light will be on for approx 2 minutes. I have Opcom and used to keep clearing fault codes but have just got used to it now. I have been told that something goes wrong with the glow plug relay but as they are working am reluctant to change it
-
Post Thanks / Like - 1 Thanks, 0 Likes
-
9th January 2012, 09:39
#5
Regular Member
The code P0380 was read again and informed it was "Device Circuit General Error".
Any ideas on what this is?
Cheers
-
9th January 2012, 09:50
#6
Regular Member
Originally Posted by
Sebastian B
The code P0380 was read again and informed it was "Device Circuit General Error".
Any ideas on what this is?
Cheers
Taken from another site - "P0380 Glow Plug/Heater Circuit "A" Malfunction".
-
9th January 2012, 09:56
#7
Regular Member
-
9th January 2012, 11:17
#8
Regular Member
Anybody else got any ideas on this?
-
9th January 2012, 11:43
#9
Regular Member
From another site:
Possible causes
- Glow Plug harness is open or shorted
- Glow Plug circuit poor electrical connection
- Faulty Glow Plug
-
9th January 2012, 14:07
#10
Bookmarks