hi trying to find how 2 for replacing rear discs and pads vectra c sri
hi trying to find how 2 for replacing rear discs and pads vectra c sri
You'll need a rewind tool to wind piston in on rear calipers mate.
also a 7mm Allen key.
And a think the caliper carrier bolt is e40 but sure someone will correct me.
Sure there will be a how 2 on it in the how 2 section.
But easy enough.
Jack up (chocking front wheels an ensure hand brake is off)
Remove wheels
Remove caliper retaining spring
Remove disc retaining bolts at this point as makes life easier if it's stuck.
7mm Allen key remove sliders ( behind rubber bung on caliper)
Tie caliper up out the way
Remove carrier (e40 a think)
Remove an replace disc
Refit carrier remembering thread lock
Wind piston back on caliper
Fit new pads
Clean an apply thin layer of grease to sliders
Refit an refit retaining spring
Refit wheels
Pump foot brake until hard keep applied then apply handbrake
Job done
Last edited by Critch; 16th December 2011 at 19:37.
Thanks for info,looked on how 2 section but couldn't find one
"Doing a good job here is like wetting your pants in a dark suit, you get a warm feeling but nobody else notices"
Maptun Tuned 2.0T Estate - click HERE for mods list.Brentwood 2012: Winner, Saturday Show. Hull 2012: Winner, Best Estate. Hull 2013: Winner, Best Estate & Runner Up, Best I.C.E
CHEERS gunna do them in morn
Nice list.
Just one thing you forgot a pair of axle stands please don't fit them off the jack.!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks