Blower only works on 4

[Sri-chris]

Has above. Been told it's switch I have not got a clue where it is how to get. To it n of cause how 2 change it and help or a diagram of some sort would be appreciated. Thanks.
O vectra c 1.2 Sri 53 plate thanks

[Sigmacca]

Very common problem, dout it is your switch, normaly the resistor, check out the link below of how to fix it

http://www.vectra-c.com/forum/showth...=1#post1495923

Good luck

[troutybrown]

http://www.vectra-c.com/forum/showth...=1#post1495923

Take a look

[troutybrown]

Snap

[Sigmacca]

great minds think alike lol

[Sigmacca]

Has above. Been told it's switch I have not got a clue where it is how to get. To it n of cause how 2 change it and help or a diagram of some sort would be appreciated. Thanks.
O vectra c 1.2 Sri 53 plate thanks

Oh and if its only a 1.2 engine I would take it back

[Sri-chris]

Oh and if its only a 1.2 engine I would take it back

2,2 was to expensive to run so put 1.2. In it. Haha

[Sri-chris]

Thanks.

[Rebellion]

Oh and if its only a 1.2 engine I would take it back

Nitrous it.

[paul_sri150]

Check the black plug on the back of heater controls, if this has worked loose, that can also cause it