ebay front splitter

[keatsy]

been looking at a splitter for the front of my vec c life...... would this fit ...
http://www.ebay.co.uk/itm/VAUXHALL-V...item3cad360d4b

only reason i ask is because the picture shows it on a sri but i cant see much difference in shape or lines to say it wouldnt fit my life.

cheers jay.

[marktaylor]

looking at it id say no it wont fit

the LS splitter is flat along the top the one in the picture is contoured

[Ginge7289]

That wont fit unless you start cutting away at it. Or take it to a body shop and see if they can make it fit somehow.

[Shogun]

Hold up... Glad I came in here lol

I was two clicks from buying this, should it be ok to go on my signum it's a facelift and I'd say sri'ish
I wanted to fit this myself to keep costs down can't be arsed trimming it to death

[happypostie]

been looking at a splitter for the front of my vec c life...... would this fit ...
http://www.ebay.co.uk/itm/VAUXHALL-V...item3cad360d4b

only reason i ask is because the picture shows it on a sri but i cant see much difference in shape or lines to say it wouldnt fit my life.

cheers jay.

Jay you have a different front bumper for that to fit .

Hold up... Glad I came in here lol

I was two clicks from buying this, should it be ok to go on my signum it's a facelift and I'd say sri'ish
I wanted to fit this myself to keep costs down can't be arsed trimming it to death

if your bumper is the same a Nige,s then this will fit as you will have the same bumper as mine , you need to look at the grill and you will see they are not the same . hope this helps . khalid

[Aikon58]

Hold up... Glad I came in here lol

I was two clicks from buying this, should it be ok to go on my signum it's a facelift and I'd say sri'ish
I wanted to fit this myself to keep costs down can't be arsed trimming it to death

It fitted on my facelift vectra elite,so not an sri bumper but it went on a treat after just a few minutes of trimming it slightly just around the sides and put it on myself and even painted it myself with my cheap hobby compressor.

[Shogun]

I think I'll throw caution to the wind and buy it, fingers crossed

[disco dan]

I bought one, from this seller.. quality was ok, painted up well but did need fettling to fit snug. BUT it took over 3 weeks to arrive.

[Shogun]

When you guys talk about trimming, you mean as in with like a Stanley knife or hacksaw blade etc?

[disco dan]

i personally used a mini dremel type thing... and a bit of fine sandpaper.