HELP! : Interior Light Switch re assemble problem

[Envy]

I am currently in the last throws of a new mod but I need to put back the interior light switch.

I had to take it apart for the mod in progress and a little metal L shaped pin fell out. I have no idea where it goes back in.

If I put the switch back in without this bit the ligth switch won't click / engage and stay there.

Any help would be fantastic as this is driving me nutts and stopping me from finishing the mod.

I have arrowed the bit that fell out.

[paulvectrac]

Just had that problem matey lol that pin goes like between the springs if u will the end where it's small faces downwards the long piece goes on the side of the switch it's hard to explain really

[kman247]

i did a how to for this , have a look for it.

You are going to have problems looking at the spring though.

[Envy]

thanks very much lads that gives me something to go on now. Phew

[paulvectrac]

That happend to my springs lucky enuf I had a spare light so just nicked a spring from there

[Envy]

Ah ha. Finaly got it back togther again and all the bits are now put back.

Still have to fit the roof compartment better but its holding for the moment.

Ah what a day,

Thanks again all for your help. I could not have done it without you !