2.2 dti inlet manifold torque settings

**slikkers** · 17th September 2011, 18:29

well ive stripped down and decoked the inlet on my 2.2 dti ,got all new gaskets for when i put it back together but i cant seem to find any torque settings for when i refit it all can any1 help

thanks in advance
rik

**Critch** · 17th September 2011, 18:38

if no one has helped in the mean time mate. once i get on my computer ill get on auto data and look for you.

but as a guesstemate id say about 45nm

**slikkers** · 17th September 2011, 18:42

Originally Posted by CritchvxD

if no one has helped in the mean time mate. once i get on my computer ill get on auto data and look for you.

but as a guesstemate id say about 45nm

cheers bud is that for all nuts or whats the differance for

bottom 10mm bolts that hold bottom down
then top part the torx bolts
also bolts that hold egr in place etc etc
ta rik

**Critch** · 17th September 2011, 18:49

im not too sure mate it was guessed from my veccy v6 derv

ill be on my comp in next half hour so will get proper info by then info if no one has has given it before then

**slikkers** · 17th September 2011, 19:01

Originally Posted by CritchvxD

im not too sure mate it was guessed from my veccy v6 derv

ill be on my comp in next half hour so will get proper info by then info if no one has has given it before then

thanks bud appreciated