Need Help Fitting Oil Catch Tank!!

[john506]

Got my oil catch tank today from ebay, with that hose that they have bend over 5 times and kinked it (I will remove them with hot water).

I just don't know where to connect them :S

Do I fit to the big fat pipe going to the throttle body and one to another pipe?

I'm a bit clueless at the moement and would appreciate some help!

Thanks guys!

[john506]

Bump really want to fit this tomorrow as I may have the afternoon off work!!

[john506]

[Penfold101]

Plenty of pictures on here mate, but the pipe that goes over the top of the engine down the front of it is the one you need to intercept and fit the catch tank to, as this is the outlet from the oil separator and the inlet back into the air inlet line...

[john506]

I did look at the pictures but I couldn't make head or tail of it! Do I Tee into it, or connect it straight in.

Or do I just basically replace that pipe with the oil catch tank and the 2 hoses?

Sorry for sounding like a dumbass!

[john506]

I think I get it.


[oil seperator]=======[oil catch tank]=======[air inlet]

[Penfold101]

Pipe goes in one connection, comes out the other and carries on to the inlet at the front of the engine. You're making the hot gases go through the oil catch tank then carry on where they were going, hopefully with less oil inside them...

[john506]

Ok thanks bud just want to be sure don't want to **** anything up!

Check my diagram in my previous post is that how it goes?

Thanks for your patience lol!

[Penfold101]

That's it mate, yeah - you're just interrupting the line...

[john506]

Waheyy I will have a bit of fun installing it tomorrow then!

Thanks again