NCDC2013 Sat Nav Swap easy or hard?

[jonnybobs]

Hi Ya,

Scrub my last post!

Basiclly, Can I just swap the NCDC 2013 and screen with the NCDC 2015 and screen (paired already)?

I have a 2013 now and mono screen and have just bought the 2015 with colour screen and phone section (eBay 110727491086)

Do I need to mess about with wires apart from unplugging and pluging back in?

Also, does my loom also have the facility to take the phone section that is located under the climate control area?

Behind the screen of my car is a spare plug) small ish... I assume this would be for the phone?

Any adbvice and help would be great!

[paulvectrac]

Inhave retro fitted some ncdc2013 I would suggest just go try it mate

[jonnybobs]

does my loom also have the facility to take the phone section that is located under the climate control area?

[bigmac]

Only way is to look for plug the small black plug behind GID is the small RGB plug for colour screen.If your car was fitted with a NCDC I would say you should have all wiring needed.

[jonnybobs]

I saw the little plug yes, strapped up behind the screen..!

Ok, what about the telephone part? how does that work?

[bigmac]

If it's all paired together screen,NCDC,telematic then all you would need would be aerial from telematic unit to rear aerial base and all should be good to go

[jonnybobs]

I cant see the wires below the climate control area for the telephone thingy... As its one that gets fitted below the heater controls

[bigmac]

They might be taped to loom.

[jonnybobs]

Where would be best place to start looking LOL

[bigmac]

Take out cubbyhole,ashtray,heater controls and stereo and shine torch in iirc it's another small plug like the one for CID