Hey everyone
Does anyone know of a way to try and refurb the door pulls as the coating around them has rubbed off and they're looking a bit tatty!
anyone have any ideas?
Cheers,
Lew
Hey everyone
Does anyone know of a way to try and refurb the door pulls as the coating around them has rubbed off and they're looking a bit tatty!
anyone have any ideas?
Cheers,
Lew
You try wrapping it. Carbon fibre wrap is very common and looks extremely well with the vectra interior but there a a load of different ones you could try to suit your fancy. And it means in future it wont peel like that.
The window switches will pop out with a screwdriver and so will the cover at the front of the door panel where the switches are. Just put a thin screwdriver down the gap at the top of the handle and pull it away. There's a clip there too but it'll come off. Window switches are the same. Just use a screwdriver to prise the whole unit out, take it apart then you can wrap the scratched parts of the switch housing too without the buttons being in the way.
Something like this would do the job and the 3M stuff is very good.
http://www.ebay.co.uk/itm/3M-CARBON-...item2eb57ed3e1
The bit that is damaged just unclips i got one from the scrappy for a pound. I have an old one if its drivers side that has couple of scuffs but no where near as bad you could have for free if you want it
Edit just looked at pic again and mines is for the other side
Here,s a link to one of the other member,s car and his carbon fibre wrap ing of the interior.
http://vectra-c.com/forum/showthread.php?t=119914
Driving vauxhall,s for 30 + years
and still loving it
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks