Just received my hid kit forms HIDs direct. Got the 50w 4300k kit. Fitted in about an hour. Mounting the ballasts was the only hard part.
Fitted with bumper and air box still in situ. Easy peasy no errors or flickering.
Just received my hid kit forms HIDs direct. Got the 50w 4300k kit. Fitted in about an hour. Mounting the ballasts was the only hard part.
Fitted with bumper and air box still in situ. Easy peasy no errors or flickering.
Awesome. Just wait till you get to use them in earnest (did you adjust the beam up slightly as well?)
Fitted them on a few other cars too. Will adjust the beam at night :-)
Good plan. I found putting the adjuster on position 1 then adjusting them back to the same height as they were on position 0, raised them up enough so as not to be over the legal height, and if I run them on position 1 they pass MOT's with no issue at all.
Now have bulb error on dash, wtf?!
Anyone else have the vectra specific kit like this:
http://www.hids-direct.co.uk/hid-con...its-p-445.html
Had this twice o/s/front not illumanating, bad connect in one connection ,wired tied all joints, no fault since. they say if problem continues they will replace ,2 year warranty
See if anyone in your area (Or if your down Portsmouth way at any time) can select HID's in the canbus settings so you dont get any errors and the ballasts will last longer.
But the kit is specifically not supposed to cause errors!
Phone them tomorrow and tell them
Got them to send me some warning cancellers. Fitted them and still get the warning! Wtf?!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks