my hid kit has landed

[marc vectra sri]

Well I finally came home and found my hid had been deliverd
It came with 5000k bulbs ballast cancellers and bulb holder from hid direct
Now I tryed my old kit well on of the ballests and bulb other day the bulb didn't stay inside the headlights 2007 facelift the bulb holders do I use them n how as the bulb just pushes in that is right ain't it or is there sumit am not doing right

[paulvectrac]

You need the holders thst are supplied with the kit mate u can use the old ones but it means cuttin a notch to slide the wires in

[marc vectra sri]

Didn't no it had a holder in the car as all I did was take the cap off and pulled the bulb slighly and it came out how you mean cutting a notch for.wires to slide

[Deztroyer]

face lift dont have bulb holders ... you just push to fit - if you find they pop back out you might need to "tweak" the holder pins to make them retain the tension

[paulvectrac]

Sorry my fault didn't look proparly

[marc vectra sri]

How do ya tweat them do I bend them in abit

[Deztroyer]

yep with a a small screwdriver or a very small set of needle nose pliers the retainer need to be pressed beck towards the front of the headlight to make it "tight" on the fitting ... its generally one thats weakened from the bulb being removed so it might look out of place compared to the others ... easier if you drop the bumper off .. remove the headlights so you can see what your doing and then you can use the purpose slot underneath the headlight for your ballasts too

[marc vectra sri]

Hmmm hope all go well for me doing it lol don't want t drop bumper as I will break sumit I always do not good at things like that cheers for the info

[marc vectra sri]

Do I install the warninig canceller capacitor or not

[DeeBe]

Yes, I fitted the cancellers to mine and there was no problems. Without them I got the bulb out warning on the dash.