Whet to change front breaks today all was going well till it came time to remove front discs. there r stuck fast and despite pounding on them for over a hour they would not move any ideas
Whet to change front breaks today all was going well till it came time to remove front discs. there r stuck fast and despite pounding on them for over a hour they would not move any ideas
spray WD40 into the bolt holes and try and get it between the disk and hub. Leave it for 20 mins then give it another bash.
I am assuming you removed the little torx screw
When all else fails use an angle grinder, just make sure you dont damage the hub.
Could also heat up the disk with a blow torch to try and get the disk to expand
Yes removed nub screw and tryed heating disc still na joy thinks me will have to go to garage
Take an angle grinder to it. Cut from one wheel bolt hole to the outside. Hopefully that will generate enough heat to get off put allow you to get more WD40 between the hub and disk.
Ye will go buy one 2moro what a pain tho
Ye just hope i dont hit hub
Oh dear!! Prepare yourself for future wheel bearing failure.
http://www.car4play.com/forum/post/index.htm?t=6462
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks