wiring from bumper into boot???? HOW

[degsy1234]

Hi All
going to fit a meta sr2 reverse sensor. How do i run the wiring from the number plate sensors into the boot/ fuse area?
Thanks in advance

[benny]

use the number plate light loom run where it goes into the body ..

[Das]

use the number plate light loom run where it goes into the body ..

thats exactly what I did with mine.

[degsy1234]

thanks. i'll have a look at it tonight when i get chance. Hopefully its easy

[jimmyred]

I also used this, there is a grommet which just pops out. I cut a segment out of grommet with craft knife to make room for reverse sensor wires. I then pulled wires tight and taped excess together then coiled it in spare wheel compartment. You can feed it behind carpet into the light cluster bay, so no wires showing. This was for the four sensors you drill bumper for; sounds like yours i s different, but method will still be same i reckon