3M Carbon Wrap

[MURDO]

Hey folks.

Just wanted to know what size of 3M carbon wrap peaople used.

I want to do my inner door handles(front and Back), Gear shift suround and ashtray.

A few diff sizes, but would like to get it right first time.

Thanks for looking.

[simmo3187]

I bought the 120mm x 30mm and this did me almost all of the door pillars with cut offs left, so im sure it will do what you need with some spare

£15 from ebay

[tomo41]

any pics of door pillars done with it buddy

[simmo3187]

will take some tomorrow for ya matey, or I will look now and see what I can do, only got the back ones done until I got a pick up the other roll from Royal mail tomorrow

looks spot on

[tomo41]

will take some tomorrow for ya matey, or I will look now and see what I can do, only got the back ones done until I got a pick up the other roll from Royal mail tomorrow

looks spot on

easy to do bud will i ave to remove seals in door to fit

[simmo3187]

Yeah its not too bad

I took off the chrome trims so i could tuck it underneath and used a sharp stanley knife

will take pics tomorrow and post them

[MURDO]

any pics of door pillars done with it buddy

Heres what DTI STEVE did. Post #25

http://www.vectra-c.com/forum/showth...=134010&page=3


I think it looks very smart if your handles are getting worn a wee bit.

Gonna order some and see how i go.