I fancy putting Insignia alloys on my SRi vectra but not sure what sizes would fit or even if the PCD etc would be the same. Can anyone help?
Thanks
I fancy putting Insignia alloys on my SRi vectra but not sure what sizes would fit or even if the PCD etc would be the same. Can anyone help?
Thanks
PCD is different.
Vectra is 5 x 110
Insignia (And new shape Astra) are 5 x 120
iirc the new astra has two different sizes depending on the engine. only the insignia is 5x120.
Unless you can get some hub adaptors that won't throw the offset to pot then i'm affraid the insig ones won't fit
I hear theres some Polish Insignia VXR rip off rims floating around that have a pcd of 5x110. Wouldn't vouch for their quality though.
Someone on here has some insignia vxr reps on his vec c!!
Really?
5x110 - 5x120 PCD hub adaptor with correct hub centre bore to suit Vectra and perhaps less then up to 15mm would get the Insignia wheels on.
I say 15mm wide max so as not to put the steering and suspension geometry too far out - should be within limits at 15mm IIRC.
*EDIT*
Not really measured up, but the Vectra hubs could even be re-drilled to the correct PCD - as long as the hub centre and Insignia wheel offset is right, then they'd fit!
I do stand to be correncted though!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks