looking for 20's

[kev smith]

hi people,hope everyones well?im after some advie? ive got a vectra c gsi,and its been lowered 40mm all round ive got 19" alloys on it already but want to stick 20" will they fit???????????

[AJA]

20's will fit mate, but it depends if you can find a manufacturer that produces the correct offset in 20's.

We all know that Irmscher do 20's in the i500 wheel (as modelled by Ian_C), and that they are now freely available through Irmscher with no restrictions apart from price

[Duncan]

And you'll need to have a bit of archwork done (iirc) to allow them to fit properly.

[AJA]

Irmscher 20's go straight on matey. The problem lies when you try and fit another manufacturers 20's; they need to be the correct offest and width.

[kev smith]

how much am i looking for irmscher ones any idea??????

[AJA]

I wouldn't have a clue matey. Send Ian_C a PM as he's quite friendly with them at Irmscher now and see if he can get you a decent price.

[Mark The Cabby]

Aja you beat me to it,

These are the 20's Aja talked about...



But if your gonna fit 20's you should have the wheel arch mod done, Which is a cut out of the wheel arch liner and replaced with a flexable peice...

The wheels in the picture are called Irmscher Evo Star's.

Part number for a set is - i 99 10 133 - Price £1597.00
Part number for single is - i 61 10 012 - Price £399.00

[AJA]

Do you know of any aftermarket manufacturers that supply 20" wheels for the Vec C or Signum Mark?

[AJA]

Here's a picture of Ian's car parked next to mine. His 20's make my 19's look tiny.



Apparently though, it's not how big it is .. .. ..

[Bainie]

You might struggle with it being lowered though, the arch work is needed standard ? so with a 40mm drop you might have a few issues as the 20`s run on 245`s, though you could probably get off with 235`s on them ?