leather

**kcmillar** · 2nd March 2011, 18:12

Hi all,
I acquired a leather interior today from a vectra c but my question is how/what do i have to connect too so the heated seats will work I did get the switches from the donor vehicle and the multi connector under the seats
Thanks in advance Keith

**John LE** · 2nd March 2011, 18:12

If the wiring is there all you need is the switches

**kcmillar** · 3rd March 2011, 19:07

i did get the switches and there is the wires behind the dash blanks for them but there is no wiring to the seats so have to run wires in but where do they go and what do i need to programme in??????

**marktaylor** · 4th March 2011, 09:55

the wiring for the heated seats is already in the big plug tha connects under the seat

connect that plug but make sure it clips in properly

connect the heated switches by pushing them in till they seat properly and viola a nice warm arse

**John LE** · 4th March 2011, 17:49

All of the wiring will be there, just plug in the black plug and put in the switches

**kcmillar** · 4th March 2011, 20:14

the wiring is defo not there fitted the seats today and found 4 wires in my original plug and 12 wires in the leather seat plug. I have the other end of the plug that i cut out the scrap car and there is defo a lot more wires than in mine