hi all
while replacing the standard bulbs to led ones on the rear interior light i pulled the ribbon a bit to hard and the black connector has pulled off the black connector but unable to re connect as there is no copper strands left at the end of the ribbon
the 3 copper strips that run tho the ribbon are covered in a film am i able to remove some of the film to get a connection again
or is there an easier fix
also i guess that that part is all connected to 1 big roof loom so i cant just replace that section?
any advise would be great i was reading one tread on here about someone doing the same but cant find it now doh
Bookmarks