Anyone got any tips on fitting one after drilling holes will a lick of a touchup do around the holes or should i treat it first with some primer or rust eater
Anyone got any tips on fitting one after drilling holes will a lick of a touchup do around the holes or should i treat it first with some primer or rust eater
Irmscher Insignia CDTI 130
MOD'S...Irmscher front spoiler, Irmscher mats, Irmscher door pins, Irmscher rear spoiler, Irmscher grille, Irmscher skirt & exhausts,Irmscher Roof spoiler MOD'S TO COME..Side skirts,Wheels
A bit of masking tape b4 u drill the holes should stop any extra paint from chipping
I would put primer then paint, then as you fit it use a spot of silicone round where the bolt meets the paint work on the outside and where the nut secures it in the inside.
Needs to be acid etch primer if it's going on bare metal. The standard primer won't offer enough anti-rust protection.
as above really Don, a little silicon on both sides will be a massive protector.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks