Vectra C Interior Vents?

**richrocks1976** · 18th February 2011, 19:19

Hi, I have a Vectra C 2.2 Direct Sri XP. Could anybody please tell me of either a link URL of a site that can tell me how to remove the interior vents. On all 4 vents the bottom flap has either come of the rails or snapped not to sure. If anybody knows of a solution on how to recify this problem or the part numbers of the vents i would really appreciate it. I know it's cosmetic but i know the problem and have to have the vents open all the time to disguise the fault.
Many thanks R.M

**Hyperhart** · 18th February 2011, 19:35

Remove your dash trim, the vents are held in place by 2 screws at the bottom.

**ChrisBilly** · 18th February 2011, 19:48

easy to remove and easy to fix. Two of mine had the broken bottom slat. Once you've got them out you'll see the clips and tabs. Take it all apart so you're left with the slats and arms. Realign the flimsy arm for the bottom slat, spread a bit of super glue over break then put a thin strip of card on each side of the arm and soak with super glue. I tried with just glue but they broke again.

**Tadpole** · 18th February 2011, 22:04

Open the front doors (for ease & more room) pull the dash strip below the vents off.
They are only a push fit, you will then see the screws as advised enabling you to remove the vents for remedial work of your choice hth ...............