User Tag List

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: What could be causing it?..

  1. #1
    Regular Member bigdave1701's Avatar
    Join Date
    Apr 2010
    Location
    York
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Vehicle InfoStats





    Default What could be causing it?..

    When a spring broke before christmas, my 2.2DTi started pulling wildly to the right. Once the spring was replaced it still pulled so I had the tracking done. It still pulled so I checked all the tyre pressures and inflated them to an even pressure but it's still pulling to the right! Granted, its not as bad as t was but its still not right! When I was doing the discs and pads last month, I noticed that both tyres on the n/s have excessive wear on the inner edge so I'm assuming this problem is an on going one and rather than fix it the wheels have just been swapped.

    Could this pull now be caused by the wear on the n/s tyres or is it possible there's another issue?

  2. #2
    Regular Member bigdave1701's Avatar
    Join Date
    Apr 2010
    Location
    York
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Vehicle InfoStats





    Default

    anyone?

  3. #3
    Regular Member ptrehearn152's Avatar
    Join Date
    Jan 2009
    Location
    norfolk
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Vehicle InfoStats





    Default pulling

    absolutely, excessive wear on the inner edge and good tread on the outer edge and you have a tyre that is not laying level on the road surface, if you were to roll a wheel (off the car) around a corner you have to tilt it, this is whats happening with yours on the car. i have had this before a few times, if the wear on one edge is bad enough the pull to one side can be quite hard and the longer you leave it the more rapid the wear will be.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. What is causing P0301 - Misfire no 1
    By myveccy in forum Y & Z30DT Specific
    Replies: 1
    Last Post: 17th February 2013, 09:16
  2. whats causing the vibration
    By sri adi in forum Vectra C / Signum Troubleshooting
    Replies: 16
    Last Post: 27th February 2011, 15:43
  3. Could This Be What's Causing The Vibration?
    By Si-SRI in forum Vectra C / Signum Car Chat
    Replies: 1
    Last Post: 28th October 2010, 18:24
  4. Alternator causing DPF fault?
    By Andiman in forum Vectra C / Signum Car Chat
    Replies: 4
    Last Post: 4th October 2009, 18:34

Visitors found this page by searching for:

Nobody landed on this page from a search engine, yet!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •