Oil filter spanner.l

[Dobs]

I need to do an oil & filter change on my vectra 2.2 direct elite.(Z22YH)Is there a special spanner/socket tool reqired to remove the top of filter bowl.I have not done this job on this car before,are there any handy tips i could be given to aid doing this job.

Many thanks Dobs

[roswell]

dont quote me on it but i think its a 32 mm socket / spanner.

[rushy]

If you use mole grips make sure you protect the plastic with a thick cloth, but as Ros said I'm sure its 32mm.

[Dobs]

Many thanks,I will try 32mm spanner/socket.Hopefully try to do it over weekend.

Dobs

[Keif]

32mm socket and a long extension. Job done!

[rob 2.2dti]

I take it its a cartridge filter ? doing mine this weekend hopefully. Got a new sump plug and washer just in case. Also a filter housing seal. Anything else i need to know ? Ive never done an oil filter in a housing before, just screw on filters.

[Keif]

Removal is easy, it may just be a little tight. Remove the large rubber O-Ring

Fitting, make sure the cap and housing is as clean as possible from old oil.
When you've fitted the new O-Ring, smear some new oil around it to ensure a good seal.
Ensure the new filter is clipped correctly into place.
Tighten the cap, but not over tight.

Nothing difficult really.

*Just a note, some caps have a 1/2" square in the centre to fit a ratchet/extension in. DON'T use it. You'll more likely damage the cap. Using the 32mm socket is the way to go.*