SIGNUM windscreen roofrail trim

**stevie1** · 9th January 2011, 19:50

new windscreen fitted yesterday due to a crack,well all seemed ok untill i noticed today that the roofrail trim which runs the length of the car and down the windscreen isnt fitted properly,how easy are these to remove and fit again correctly yourself ? are they easily broken ? cheers steve.

**Super T** · 9th January 2011, 20:42

Just tiger seal it down!! It will be fine.

**stevie1** · 9th January 2011, 22:00

Originally Posted by Super T

Just tiger seal it down!! It will be fine.

what is tiger seal ? it sounds like a bodge up,something i wouldnt do.

**Jezzy** · 9th January 2011, 22:10

If you use sealant it's that much more hassle if the windscreen has to be replaced again.

**stevie1** · 10th January 2011, 19:16

dont want to use any sealant as it doesnt need it i just want to know if they are easy to remove yourself and refit correctly without breaking them thanks steve.

**poves** · 12th January 2011, 18:04

They just clip on and off ,
start at the bottom and work upwards , then refit in reverse.

**stevie1** · 12th January 2011, 19:21

Originally Posted by poves

They just clip on and off ,
start at the bottom and work upwards , then refit in reverse.

cheers 4 the reply i will give it a go at the weekend

**GrahamS** · 23rd January 2011, 14:27

I need my windscreen replacing and noticed these trims.
Then I noticed they ran the length of the car!

Do the Autoglass fitters know how to remove these without breaking them and are they responsible for them if they snap them?
They're body coloured so not going to be a cheap replacement I 'spose.

Would I be better off going to the Autoglass centre rather than relying on the mobile guy?

Cheers,
Graham.