easiest way to fit fog light bulbs vectra c

[bridge_eee]

hi guys whats the easy way of fitting the fog light bulbs on my vectra c face-lift as doesnt look to easy.
many thanks

[soulman]

well if its the same as the pre-face ..you lie in the floor and feel under the foglight and there should be a locking cap there .

[Jezzy]

well if its the same as the pre-face ..you lie in the floor and feel under the foglight and there should be a locking cap there .

No, on the facelifts you have to remove the rear bumper, the steering wheel and the DMF. lol, just kidding.

[keefy*2010]

well if its the same as the pre-face ..you lie in the floor and feel under the foglight and there should be a locking cap there .

I find it helps to put the front wheel of the side you working on up on the Kerb, gives you another few inches to sqeeze under and see what you are doing.

[soulman]

No, on the facelifts you have to remove the rear bumper, the steering wheel and the DMF. lol, just kidding.

[paul_sri150]

easyest way is bumper off

[Ademusic]

You can do it just by getting underneath. Jack it up at the front and you can get to everything you need to.

[hutch]

easiest way........get someone else to do it LOL

[bridge_eee]

lol cheers guys so its basicly a bit of a pain but not too bad.

[neverlandandy]

bumper off which only takes 10 mins much easier than laying on the ground