screws in wheel arch

[bower]

im just taking my bumper off to fit rear parking sensors and on the how 2 it says theres 3 screws in the wheel arch but i can only find 2
is there 3 or 2? mines an 08 facelift
thanks

[WilliamLX]

'screws in wheel arch' - boy you and the partner must be both small and agile....sorry couldn't resist. Just had a look at my car, I can see only 2 as well (08 face lift).

[bower]

lol thanks mate

[VectraElite 2.2DTi]

mine is a 54 plate pre faclift and mine has only got 2 aswell

[Grumpy1954]

Mine's an 08 SRi. had the bumper off to fit reversing sensors, I only had two in each wheel arch as well.

[bower]

cheers everyone
one last thing do you have to use those angled washers that come with the parking sensor kit? or if they fit flush without them is that ok? also is there a certain way the sensors go in, is there an up or down?
cheers

[Grumpy1954]

cheers everyone
one last thing do you have to use those angled washers that come with the parking sensor kit? or if they fit flush without them is that ok? also is there a certain way the sensors go in, is there an up or down?
cheers

On mine there is an up, marked on it. Also make sure leads are same length, if not use the shortest ones nearest where the module is going (mine's in driver's side cubbyhole).
I didn't use any washers, mine fitted flush, mine's a hatchback, can't answer for estates.

[bower]

there doesnt seem to be a up mark on mine, mines a gadgetman.
will just stick them in and see how it goes!!!