As the title states!
Have driven over 30'miles and car and spanner light is still on, tried dissconnecting battery. Took clocks out again to double check no problems and now airbag light is on also!
Help!!!
As the title states!
Have driven over 30'miles and car and spanner light is still on, tried dissconnecting battery. Took clocks out again to double check no problems and now airbag light is on also!
Help!!!
On a 150? and error light?? Never
Have you looked for the pedal method on here for reading the error codes? It may work it may not. For the airbag light, do you or did anyone move the front seats or clean under them? They may have disturbed the plugs under the seats.
Oooooo pull that knife out my back haha!
I haven't tried that yet, airbag light has now gone out on way to work but car and spanner is still there
Im hoping that it's just a change in voltage or me connecting/dissconnecting whilst ignition on that's thrown the error up, fingers crossed it clears itself
Last edited by paul_sri150; 19th September 2010 at 20:33.
I take it everything works as it should? If it does you need the error/fault codes
Have you put the led in the right way mate? Before I put any of my LEDs is I bench tested them all, I found a few duds so it saved me time in the long run. Even a stray bit of solder could cause the lights SMD's to misfire as it were.
I cant remember now but are there any 4 pole smd's in the dash kit?
The spanner light is for engine faults only.
Find the error codes and post them up
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks