Does anyone know what colour the 2 cables are that i need to fit the 2 cables to on my parking sensor kit. Im talking about the 2 cables on the reverse light.
If you can let me know which one is + and what colour - is as well. Cheers guys.
Does anyone know what colour the 2 cables are that i need to fit the 2 cables to on my parking sensor kit. Im talking about the 2 cables on the reverse light.
If you can let me know which one is + and what colour - is as well. Cheers guys.
Crespo cant remember the colour off hand but the bottom wire on the back of the light cluster that is the positive for the reversing light. Hold on i'll nip out and have a butchers.
Yup bottom black and white, brown at the top for the earth mate.
White with black tracer ( be careful there is a pale grey wire with black tracer I first mistook for the reversing light feed)....the other direct to chassis/earth/ground I drilled a small hole in a metal flange behind the sensor kit & self tapper screw.....
My post below may help ....although this is for a 6 x sensor Kit..2 x front & 4 x rear....
Electrical Diagram I drew & used to suit my idea for the above...
http://www.vectra-c.com/forum/showpo...5&postcount=11
Sensor Kit fitted with teporary connection to test operation of my kti.........
Hope it helps....
Other thread on here on parking sensors will also help...
Cheers
Cheers. Back in an hour hopefully with some pics of a job well done.
All done. unfortunately the colour is slightly off my Ultra blue so i will have to spray them at some point. its not a million miles out but i notice it and it will drive me nuts.
Still cant complain for 15 quid.
The old OCD eh crespo I was the same when i fitted my spoiler, was only about 1mm out each side but id still notice it, so off it came and was refitted, LoL.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks