Has anyone here done a facelift? std sri bumper (not xp2)
Where do you make the holes? i can't see any markings on the inside of the bumper.
Pictures appreciated
Keith
Has anyone here done a facelift? std sri bumper (not xp2)
Where do you make the holes? i can't see any markings on the inside of the bumper.
Pictures appreciated
Keith
You sure it's not on the back of the bumper? My bumper has the area marked out underneath each headlight where the washers go. Had the marks for the parking sensors too
i have just had another look. is it an oddly shaped marking? also... can you see through your grille to the radiator. the one i have got has a panel on the back of it. how does the air get through?
The bottom grill you can see through to the rad, the top V grille has a backing plate and you can't see through it. I think the lower grille is a larger opening than on the PF so that lets enough air in. The headlight washers are directly below where the headlights are and should look like a bent rectangle / trapezoid shape, like in the picture below
Slightly better pic of them. This is the sort of shape you should see on the back. Mine's only a standard sri bumper and mine has them there, so hopefully your one should too
cheers mate. i only want to fit the washer covers to give it the look. not fussed about them working. do you know how much the stealers charge for them?
thanks again
There was a thread on here with the part numbers etc for each cover. If I can find it, I'll post it on here for you
Part numbers all here for you http://www.vectra-c.com/forum/showth...+washer+covers
cheers mate. i appreciate that
Id like to get these working, doesnt look to difficult. Might be worth doing it when the car is stripped ?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks