some of you may have read on my earlier thread that i was rebuilding my engine due to burning oil, well the rebuild was completed and engine turned over with the coil pack disconnected until i was certain there was oil pressure,
i ran her a few times letting her getting up to operating temp before taking her out today and talk about hold back, there was no eml and will not rev past 4000rpm, i know i should not be reving that high till its run in but it was only quickly to see if it was limp home mode, i should also say that previous to the work the car was starting almost straight away and now is taking 8-10 seconds of cranking before starting. but when it is started it ticks over fine
i read the fault codes this evening and i got the following
P0335 - Crankshaft Position Sensor "A" Circuit Open
(04) - Present
the only time i touched the crankshaft sensor was to clean a load of grey sludge and metal filings off of it
Bookmarks