gave the car a good old spring clean (well missus cleaned up little girls spewy!) & pulled out the rear seats for the first time & noticed wired connectors there! Would these be wiring for hated rear seats?
Car Is a 56 plate Elite.
gave the car a good old spring clean (well missus cleaned up little girls spewy!) & pulled out the rear seats for the first time & noticed wired connectors there! Would these be wiring for hated rear seats?
Car Is a 56 plate Elite.
Check the rear ashtray/12V Socket panel there conectors for the switches are located there, however I have a 54 plate Elite and the switch connectors are not there due Vx and their wonder cost cutting regime. I havent checked the rear seats though.
If you are lucky and you have all connectors, you will need the heating pads for the seats and a tech 2 session at Vx dealer to activate them.
Gazza4
Same as mine, plugs are there ready. I had the fronts too so just added the switches and away i went (didn't need a tech2 session)
According to the How 2 they need tech2'd:
http://www.vectra-c.com/forum/showthread.php?t=15094
Gazza4
I did not need a tech2 session either.. put in the switches and done..
Where abouts on the seats did you find them... i have the under ashtray blocks. but just assumed the seats would not have the wires in mine?!?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks