need to run wires from exhaust tip to battery??

[vectra_c_wannabe]

hey people,

got some undercar leds on order (yes i know they are abit ricer before you comment)

however i found a good place to mount them but i need to run the power wires to the remote control junction box next to battery??

where can i hide them away from eyes and heat??

if i move the junction box then i need to run wires from front to back rather than back to front so that wont work, and i cant take positive from the boot fuse box becasue i need to connect them to the junction box to work off wireless remote control??

[lizard]

Run them from the rear fuse box insted of to the front of the car, lot easier IMO, whoops, just re-read above post. Me numpty lol

[bigdave1701]

If youre able to get the wires inside to the rear fuse box then surely it cant be too hard to hide them within the lining of the cars interior and then back out of the bulkhead?

[Leemarksmith]

What colour kit are you running and what are the lengths are they, sides and f/r pieces...

Think you can get away with just over 60cm if attach the rear onto the wheel well other wise exhaust will be in the way!?!, i'd be tempted to then drill up through there and feed the wires through the boot and along the passenger side, then into the engine bay from behind the glove box...

Same with the sides but come up from underneith the side skirts, and feed the wires behind the wing and wheel arch covers. once inside again meet behind the glove box...