Hi guys my parking sensors have stopped working and there is just a bell sound when I turn it on! Any ideas guys
Hi guys my parking sensors have stopped working and there is just a bell sound when I turn it on! Any ideas guys
Usually means one of the sensors has become disconnected - quick inspection of front and rear with bumpers off should tell you...
Or maby if you put in the new roof loom you have disconnected some of the wires in the REC when plugging in the new loom?
Thanks guys-rec?.... Where is that ?
Rear Electrical Centre
This thread is repeated here.
http://www.vectra-c.com/forum/showth...06#post1236706
REC = fuse board on uk passenger side of the boot / load area
(or drivers side of non uk vehicles)
right guys ...........following on from my park pilot not working, its the loom i have used for the interior bits that doesnt have the park pilot loom on it!!is it possible to run four wires from the park pilot loom into the rec or onto the new ribbon?..........thanks for all your help again
What connections are you missing to the REC there should be 5 in total 2 for speaker, 2 for Low Speed Can and a 12v feed?
hi mate.......the loom i have plugged in has two ribbons coming out of the plug, a thick one and a thinner one!! i assumed the thinner one for the park pilot but there is no plug on the loom to the speaker on the headlining!................then i have a totally separate plug - which i assume is for dimming mirror.
can i run the wires from the old lead into the new loom,can you pull them out of the plug without breaking it? or simply just insert some wires and link them both together,
as always help is appreciated, Andy
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks