started about 5 days ago and since then ive replaced my power steering rack as was leaking.and this light was on before it went only a few days,but thought it would go when rack was changed but its not its still there,is there a way to reset it?
started about 5 days ago and since then ive replaced my power steering rack as was leaking.and this light was on before it went only a few days,but thought it would go when rack was changed but its not its still there,is there a way to reset it?
hiya mate i dont think this light means anything bad but just needs a service and needs to be reset when completed using the scanner/computers, you could just go to local garage and ask them to plug itin to computer and if it is a problem light it will tell you the fault before you splash your cash
hope this helps
This is a fault light mate. Get the codes read
steering angle sensor on the rack need calibration and low fluid can bring the light on
had the power steering rack changed few days ago mate,so would it just need resetting do you think?
thanks all for replying
will possibly need the steering angle sensor reprogramming to the new rack but this would usually illuminate the EHPS light as opposed to the one you have definatly needs the codes read if you can get down the lancs i'll do it any night in the week
Looks like you have a little Christmas tree at the side think your display is on its way out
Irmscher Insignia CDTI 130
MOD'S...Irmscher front spoiler, Irmscher mats, Irmscher door pins, Irmscher rear spoiler, Irmscher grille, Irmscher skirt & exhausts,Irmscher Roof spoiler MOD'S TO COME..Side skirts,Wheels
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks