Well being a numpty I opted for the 'at home' convenience of remapping my car which has gone horribly wrong.
I won't say who the remap company is because I'm hoping a call to them tomorrow will sort all of this out but it's my fault for doing this out of hours at work!!!
Anyway, car was read successfully, I saw my VIN - engine number etc etc and then chose my map. Wrote successfully to the device, connected it to the car - all went well flashing happily then WAM, started flashing a red light. I left it for the required time and nothing - connected to PC and it said failed reflash (duh!).
So, tried again and it wouldn't write. So, started fresh and now it won't even read my ecu details just starts then flashes red again!
Has this happened to anyone and I'm hoping it's not completely fubar'd!
My car won't start and I've tried d/c the battery and nothing still fails to read ecu now.
I also have F Miles on my readout!
If anyone is doing a remap at home I would hold off if I were you!!
Bookmarks