Look what I picked up

[parsco]

LINKY

Bargain me thinks

[Dose]

BARGAIN mate!!!!

[kev bux]

nice one mate.

[Penfold101]

Even in the right colour - good job mate

Don't forget you'll need the new plastic rivets to attach them which is only a ten minute job each side...

[parsco]

Even in the right colour - good job mate

Don't forget you'll need the new plastic rivets to attach them which is only a ten minute job each side...

Anyone got part number for these plastic rivets? How many am I going to need?

[Penfold101]

These are the ones mate, about 6 per side max

http://cgi.ebay.co.uk/Vauxhall-Bumpe...item3a586d8a9c

When I got mine they came as a kit including the black plastic half-moon parts that attach on to the holes where the jacking points are. I'm not sure what's on your current skirts so it may be worth having a look at them and seeing if you can just swap them over. If not, speak to Danboy and see if you can buy them seperately as he should be able to find them on EPC. Typically, these bits use smaller sized rivets...

[parsco]

Cheers mate just bought some.

Hopefully easy enough to fit. Is it purely held on by these plastic rivets or are there some screws at either end of them

[Penfold101]

Nope, just the rivets and depending on your model something at the rear end. Again, part of the fitting kit contains two bracket-type affairs that sit on each end of the sideskirt The skirt hooks on to this. They were already fitted on mine as I had Irmscher side skirts but not sure what comes on the standard model. Either way it's jsut the rivets that hold them on...

[darko2301]

Cheers mate just bought some.

Hopefully easy enough to fit. Is it purely held on by these plastic rivets or are there some screws at either end of them

nice buy mate

it is extremely easy to fit them, but you will need i think 12 rivets per side, not 6.. they are held by rivets only and there are no screws

btw here is the how2

http://www.vectra-c.com/forum/showthread.php?t=27850

[Penfold101]

nice buy mate

it is extremely easy to fit them, but you will need i think 12 rivets per side, not 6.. they are held by rivets only and there are no screws

btw here is the how2

http://www.vectra-c.com/forum/showthread.php?t=27850

Right, now why didn't I think to look for that... Would have saved me so much typing...