got the above today but no wire in the dash dose anyone know where they will be as i think someone on here said they will be taped up in the dash thanks andy
got the above today but no wire in the dash dose anyone know where they will be as i think someone on here said they will be taped up in the dash thanks andy
If that part of the loom is fitted, then the plug will be tied back inside the centre facia section (behind the switch / radio, heater control panels.
if you have taken out the blank and its not there i doubt you will have the correct loom, you can always sell it to me!.
You can always put in wires for yourself, let me know, and I can supply a wiring diagram / pin out list for this. complete with colours, function and destination points
nah, I can post up on here,
It will probably be tomorrow night now, just bear with me.
It will give me chance to check my info, and produce a list / table for you.
Are you wishing to have a working switch, or just one that lights up (for effect).?
Note - even some cars with the connectors pre-fitted, have non switchable TC.
Better still, there is a link here to a thread about this, check out the drawing on page 2
http://www.vectra-c.com/forum/showth...h+works&page=2
Last edited by Robsey; 22nd March 2010 at 00:39.
my signum didn't have the blue plug behind the dash i got one from local breakers and wired it in (really easy) and it works
I dont think it will work... U should just sell me ur switch
I can see the Vultures circling
Just keep moving and you'll be fine
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks