ABS Sensor Plug does not fit/work

[callist]

Hi, I ordered a front wheel bearing from a company.. I provided them with my reg and they sent out the correct bearing (they said I need the one with IDS) * Interactive Driving System.. Anyway.. I replaced the bearing and got around to plugging it up.. until I noticed the new plug did not fit! It would only go in 3/4 of the way... I experimented by trying to turn the ignition on with it in 3/4.. The ABS light still showed. I then placed the original back in and the ABS light went out..

I then sourced a second hand connector (car end) and cut the black plastic locator down a bit. The new plug then sat in nicely.. but still.. an ABS light, yet when I place the original back in, the light goes out!

Have they giving me the wrong part..? The amount of time I spent in replacing the part was silly.. as the bearing was seized inside the knuckle.. I'd be really peeved off if I have to go through this again.

Thanks.

[John LE]

Do you have ids? Do you have the sport button on the dash?

[signumturbo04]

the abs sensor levers off the back of the hub, you can use ur original sensor and wires!! i had this problem on my signum

[callist]

Hmm, No, there is no Sport button on the dash. Does this mean the car does not have IDS? I gave them my registration and they worked out which model I needed.. ugh..

I like the idea of swapping that sensor parts around.. I may try that!

Cheers guys.