Err, sorry, that should read... 'How do I get the gear knob off ?'
Mine has developed that annoying click each time I change gear and I would really like to fix it before it falls off. Any ideas ? Vectra CDTi 07-reg. Thanks.
Err, sorry, that should read... 'How do I get the gear knob off ?'
Mine has developed that annoying click each time I change gear and I would really like to fix it before it falls off. Any ideas ? Vectra CDTi 07-reg. Thanks.
LOL MINE WONT STAY ON think your self lucky
Get a block of something and bang it off from underneath,a few have done this and it just flies off,but you have to hit at the right place.....
this must be what has been done to mine pmsl some 1 must have gave my knob a good bang lol wen i change gear it just pops off in my hand some times lol
You will require the following :- LARGE HAMMER, LARGE DRIFT, LARGE HACKSAW and LARGE MUSCLES and a portion of luck. A lot of people have tried to do this and most end up using these.
Last edited by Sparky67; 6th March 2010 at 14:51.
hi i had the same problem gear knob clicking and i fixed it quicker than it took to write this, prise out the center plstic bit that has the 123456 speeds 0n it it just pops back in but be gentle then with a hamer and a drift look in side the top off the gear knob and you will see a ali round bit, not too hard but a small frim knock down towards the center in line with the gear stick and no more click ive done 1000 miles since i did that and still no click.
My signum had this annoying ptoblem until today when it popped off in my hand when changing gear at traffic lights!
VX dealer quoted £200 for a replacment(you need to replace the whole gear lever)
They suggested some araldite would be a cheaper solution.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks