Help Brake rewind tool

[eaglepva]

Anybody got a rewind tool i can borrow, im in hartlepool, but willing to travel or pay for recorded post their and back also pay a deposit if required.

Cheers
Ash

[myelite150]

hi mucker now i got the box tool that i used on one side of the brakes but as i made myself a proper tool i used it for the other side i am willing to post the tool to you know probs and it does work you just need to push it hard and turn it with a 3/8th ratchet tool

[eaglepva]

Hi mate, that would be grate mate car currently sat outside on drive as i can get hold of a rewind tool and the long nose pliers dont seem to work. How do you want paying for the postage mate, can also pay a deposit if required untill tool is returned to you.

Cheers and thanks.
Ash

[hairy31]

Anybody got a rewind tool i can borrow, im in hartlepool, but willing to travel or pay for recorded post their and back also pay a deposit if required.

Cheers
Ash

I did mine today and just used a G clamp

[myelite150]

dont worry about the deposit mucker i am a trusting guy so if you send me your addy by private message and i will nip to posty to have it weighed and see how much it is, also me and damiens are trying to set up a tool hire by post on the site and has been passed by admin so you could maybe keep it until someone else wants it (aslong as u can keep it to han d)

this will be for the box tool mucker ok just to let u know and u need a 3/8th ratchet spanner ok, i also got a few tips on best way to use it too i didnt need a g clamp either u just need a bit of elbow grease and push it hard at first whilst turning then it just winds in itself with slight pushing (clockwise)and i will give u my mobile number if you get stuck so i cant say any fairer than that mucker ok

[eaglepva]

I did with the fronts mate, but the rears need to be wound back in.

[hairy31]

I did with the fronts mate, but the rears need to be wound back in.

yea i know mate.did my fronts and rears today, as you tighten the clamp on to the piston keep turning and it winds in" SIMPLES"

[eaglepva]

upto you mate, if you want me to keep it untill somebody else needs it thats fine i got a safe garage. Or i can send it back once used. I have ratched spanners etc. Any pictures of the tool so i can get a idea of how to use it.

[myelite150]

this is how i used the caliper for support by refitting bottom caliper bolt to top carrrier hole
and just unclipped the hanbrake cable on suspension arm
i not got a pic mucker and when you get it you can only use it one way and it will only fit on one way too
a little fiddly but it good tool i ground down the small edges (u will see) and put them in hole so that the other two pins are on the outside of the piston u will get about 3/4 of a turn out of it then you re fit it simple muck .
search on ebay for it and see one

[eaglepva]

Hi mate did you get a price for the postage of the tool.
Cheers
Ash.
P.s have looked on ebay but cant find the one you refer to.