Put some insignia fan style jets in today but they need slight adjustment , anybody done this?, didn't want to start trying to maneuver the jet as they look as though they would damage easy.
Put some insignia fan style jets in today but they need slight adjustment , anybody done this?, didn't want to start trying to maneuver the jet as they look as though they would damage easy.
You need a special tool to do thhis proporly.
I wouldn't happen to be the drivers one that's too low would it?
http://www.vectra-c.com/forum/showth...signia+washers
Have a look here mate.
its the drivers side low and the n/s slightly tilted.
I think it's the drivers side that causes most problems on the Vec - does anyone know if the Insignia wiper has some sort of kink in it to allow the jet to clear?
Here is a photo of the adjusting tool I made for my Insignia washer jets.
It alows you to move the jets from left to right, up and down and rotate.
That's very smart, how long did it take you to make?
can you buy the part from vx as ive just fitted them and the drivers side is to low.have tried the how 2 with the pen top i keep on cutting them to thin.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks