Had to replace 3 resistors in the last week for my heaters, been told the problem might be the heater motor drawing to much power causing the resistor to blow, any one had this problem before, how hard is it to change the motor?
Thanks
Had to replace 3 resistors in the last week for my heaters, been told the problem might be the heater motor drawing to much power causing the resistor to blow, any one had this problem before, how hard is it to change the motor?
Thanks
Have you checked to see if the motor spins freely or is semi siezed?
Motors is fine atm just replaced another resistor and it working well atm
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks