As above, the door will not open from the outside, but can be opened from the inside, when pulling on the door from the outside, it feels a little easyer to pull that the other doors.
Could something need tightened, or has something broken?
As above, the door will not open from the outside, but can be opened from the inside, when pulling on the door from the outside, it feels a little easyer to pull that the other doors.
Could something need tightened, or has something broken?
Took the door handle off completely from the outside, the lever is still attached to the handle when you push it in, you can feel a little resistance when pulling, but not as much as a working handle, I supose this hasnt happened to anyone before that knows a quick fix or what sort off bill im looking at?
Haven't a clue buddy sorry so here's a free
Irmscher Insignia CDTI 130
MOD'S...Irmscher front spoiler, Irmscher mats, Irmscher door pins, Irmscher rear spoiler, Irmscher grille, Irmscher skirt & exhausts,Irmscher Roof spoiler MOD'S TO COME..Side skirts,Wheels
hi mate whip the door card off and look from inside at the lock its self make sure the rod that comes down from handle is sat in its plastic clip properly check that the rod isnt been obstruted by anything.this was a big problem when i worked for fiat on the stilos which have the same set up hth
Thanks mate, I half took the door card off today also, noticed that it was covered with a plastic sheet, can that be detached if I need to put the metal rod back if it has came off the clip?
Cheers
sorry for delay mate being on bathtime duties the plastic sheet is called a membrane it stops any water that gets past the window seals entering the car what i normally do is cut a flap in it where you need access do the work then stick it on both sides with gaffer tape which is waterproof.if the rod has come out push the rod back into plastic clip then rotate the clip,
No worries, thanks alot!! - Will give that a go the next dry available day, - the mechinism works from the other side, so this seems to be the solution im after cheers!!
Easiest thing first.
Make sure the child lock is not engaged.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks